Testing Board

This photo is a top view of the testing board designed and fabricated by Don and Mike. It is actually about 4' wide x 2' high.

The right side is the DCC input. The DCC system has been removed in this photo.

The center section is for switching, and you can still see the Soundtraxx DSX decoders courtesy of Soundtraxx, that were used for testing.

The left side of the board shows the quick-connect terminals for testing up to 6 speakers at the time.

Not shown is a decibel meter that was suspended above the speakers to insure that the speaker setup was always at the same volume for each speaker.

We welcome comments or suggestions from readers; please write or call.